![]() ![]() Once you select “Prepare time envelope”, the “ENV” screen below automatically appears (Notice the two drop downs above the envelope display “Image time offset” and “Envelope” – so that you may get back to the display when you want to). Hit the circular drop down again and select “Prepare time envelope”. The following screen appears once you make the selection.ĥ. Hit the button and select “Set viewed zone as loop region”: Above the image of the sample information is a circular drop down button that contains several options for manipulating the image information. We are looking for peaks in the intensity of the image horizontally where we can repeat, reverse, or hover around.Ĥ. By analyzing the graphic representation we can find areas (points of interest in the image below) in the representation that will be good candidates for manipulating through an envelope. You will notice the sample once dragged into the “image section” has a graphic representation. Drag the sample file you want to use into the “image section” This saves times for creating future presets from samples.ģ. ![]() Finally, save this preset as “HQ_Resynthesis” in the Template directory.Fourth, go to the bottom “Freq” filter knob, choose “Class high pass” from the drop down, then right click and choose “Quick Map To” -> “Modulation Y”.Third, go to the top “Freq” filter knob for which should be set at “Crude low pass”, right click and choose “Quick Map To” -> “Modulation X”. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |